[DFW]: DFW's Lounge
09-14-2009, 10:48 AM
#8861
Registered User
iTrader: (1)
Join Date: Sep 2007
Location: Frisco, TX
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
I posted some pics of a car that I took a few weeks ago on 121 going through the Colony. Maybe it is the same one you saw. I can't tell if it is the same one as the one from today, but it is darn close. The ones today were from the Wal-Mart at 121 and Ohio in Plano. I really hope there are not 2 of them driving around this area.
I saw that car on main street ( colony area )
09-14-2009, 12:40 PM
#8865
Booooosstt!!
iTrader: (58)
Join Date: Mar 2007
Location: Dallas/NewYork/Michigan/Korea
Posts: 5,311
Likes: 0
Received 0 Likes
on
0 Posts
Sorry to hear kristi, hope everything works out well. And shoot me a pm whenever you guys have a free time, we can set the date. so i can drop off navi CDs.
09-14-2009, 12:52 PM
#8867
Registered User
09-14-2009, 12:55 PM
#8868
Registered User
... I always thought I had kryptonite coursing through my veins 
09-14-2009, 06:17 PM
#8874
New Member
iTrader: (3)
Join Date: May 2004
Location: Allen, TX
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
this might be a coincidence but yesterday we had an alarm installed on kristi's car. Everything was fine until we were about to leave. The Service Engine Soon, TCS OFF, and SLIP lights are all on and you can floor the gas pedal and the car will barely go.
When you start the car the rpms drops and the car dies or rpm drops and it has a rough recovery to idle or you give it a little gas when starting and it will idle
I have pulled the battery for 6 hours and tried again and the lights are still there. I even tried the manual ECU reset by turning key on and hitting gas pedal but nothing.
ANYONE?? I have not pulled codes yet.
When you start the car the rpms drops and the car dies or rpm drops and it has a rough recovery to idle or you give it a little gas when starting and it will idle
I have pulled the battery for 6 hours and tried again and the lights are still there. I even tried the manual ECU reset by turning key on and hitting gas pedal but nothing.
ANYONE?? I have not pulled codes yet.
09-14-2009, 06:58 PM
#8876
Sleeps in 350Z
iTrader: (24)
Join Date: Mar 2007
Location: Flower Mound , TX
Posts: 5,745
Likes: 0
Received 0 Likes
on
0 Posts
this might be a coincidence but yesterday we had an alarm installed on kristi's car. Everything was fine until we were about to leave. The Service Engine Soon, TCS OFF, and SLIP lights are all on and you can floor the gas pedal and the car will barely go.
When you start the car the rpms drops and the car dies or rpm drops and it has a rough recovery to idle or you give it a little gas when starting and it will idle
I have pulled the battery for 6 hours and tried again and the lights are still there. I even tried the manual ECU reset by turning key on and hitting gas pedal but nothing.
ANYONE?? I have not pulled codes yet.
When you start the car the rpms drops and the car dies or rpm drops and it has a rough recovery to idle or you give it a little gas when starting and it will idle
I have pulled the battery for 6 hours and tried again and the lights are still there. I even tried the manual ECU reset by turning key on and hitting gas pedal but nothing.
ANYONE?? I have not pulled codes yet.
Dude,
I would have driven it right back to them and have them figure it out ?????
That is Crap ! They should be responsible for anything that happened.
Have them go back and trace the install to see where the problem is most likely.
SUCKS for you ! GL
