When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Right around 2 up front (dependent on actual tire width) Easy way, remove the spring , compress the suspension and set the camber to the point is will still clear.
I DD my car with -2.2 rear and -2.8 front, and drive well over 400 miles weekly.
Right around 2 up front (dependent on actual tire width) Easy way, remove the spring , compress the suspension and set the camber to the point is will still clear.
I DD my car with -2.2 rear and -2.8 front, and drive well over 400 miles weekly.
Yes, but you don't have that 295 rear on a 10.5 +15, right? I think that's a tough fit in the rear. Even the 275 will be big without enough camber.
What's the least amount of camber I could run with 18x9.5 275/35/18 front and 18x10.5 295/35/18 rear? Right now I'm at -2.5 all around, fenders rolled. Looking at the clearance I think I can go down to -1.7 to -2.0.
My Daily is down, and I'm not sure how long, so I want the Z to be a bit more street friendly.
If you see my setup a page before, I know that I could definitely fit a 295/35 out back, and I'm not sure about the 275/35 (265/35 could definitely fit) and I am -2 all around. I don't know where your ride height is at but it's definitely doable. Fenders rolled and I have never rubbed after 1000 miles of jersey roads
*just saw your first post. you seem to be about the same height as me in the back so should be fine. The front seems lower so I don't know up front.
Hey thanks everyone. I'm going to try -2.0. I may need to try to roll the fender a bit more. I didn't go all the way because I'm clearing the fender now.
Nice prerunner look, i typically would run my Z level or slightly taller in the rear. Not to mention your rear tires are not even tall enough to be a front tire , having a setup like that leaves the wheel well arches unfilled and the car looks like evenb more azz.
No, i was thinking about measuring it this weekend, haha. I noticed it as soon as i saw that pic and wondered because i dont notice it when looking at the car in person.
Should be fun, sticky, and fast! You are a net +15 offset with the spacer, or you added a spacer on top of the +15 offset?
i was told the wheels are +15. the spacer is not much. like 5mm or so. it just needed room for the inside of tires to clear. I need to take a look at the wheels when i take them off to be sure though since i just bought them and test fitted this weekend.