Looking for a set to replace the front rotors on my car...anyone know if these are regularly offered by anyone?

TIA

Adam

 

What car is this for?...stock calipers, etc?

 

Brake Pros...

 

J Ritt - for 04 350Z...4 piston AP caliper. I have one piece rotors now, want to upgrade to a 2 piece

 

how about 324x30mm?

 

wont work with my calipers

 

too bad, i want to help.
but the only thing i can recall thats similar to the size you wanted is 224x30.
good luck

 

I dont think it's too uncommon of a size...have to do some more research on it Other issue of course is the hub has to have the right offset to it, or else it wont fit the wheels, etc

 

how about 332x32?

 

The rotor size has to be exactly the same as the rotors I use now. You have to remember the caliper clamps both sides of the rotor. So it cannot be any bigger in circumference that 330mm, or the pad will not clamp onto the rotor in the proper location. It also cannot be any wider than 28mm, or you run the risk of the pads constantly rubbing on the rotor face (although they do this anyway, if you go with a thicker rotor, it will be even more pronounced!

Hopefully Stoptech has something for me I've looked at a verity of JDM brands too (ie replacemetn rotors from Endless, Project Mu, etc that are for other RWD, relatively low offset 5-114.3 cars) but have not found anything yet.

How do you like the new Endless ones (yeah, I noticed you added them to your sig ; )

 

aite, guess i am just being annoy instead of doing any help
the endless are crazy, period.i wasnt expecting stoping distance to decrease this much, the only reason i swapped to this is because the stock brembo isnt enough.i was only expecting it to hold up more heat, but damn! the stoping power is really crazy men.unfortuantly my season of the year is done, got to wait at least feb next year to have my next season!

 

looks like I can go to a max thickness of 32mm and max diameter of 330mm according to AP (IIRC I have AP5200 calipers)

 

that'll b easier

 

I know that this is a super stale thread but did you ever find a solution for this? I'm in the same boat with the old Stillen 4-pot AP racing kit in the front with the CP5200 calipers.