Turn signal problems
#1
Registered User
Thread Starter
Join Date: Jan 2023
Location: Cascais
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Turn signal problems
Long story short I bought out ‘08 Z and the headlights were all busted. I wanted to get it registered and needed to replace the headlights. I bought some Spec-D headlights and put them in but here’s my problem. I put the turn signal on and nothing happens. I turn on the headlights and the DRL leds turn on and then I put the turn signal on and the DRL’s start flashing. Anyone know what the correct wiring should be or how to check that out??
#2
New Member
iTrader: (2)
Long story short I bought out ‘08 Z and the headlights were all busted. I wanted to get it registered and needed to replace the headlights. I bought some Spec-D headlights and put them in but here’s my problem. I put the turn signal on and nothing happens. I turn on the headlights and the DRL leds turn on and then I put the turn signal on and the DRL’s start flashing. Anyone know what the correct wiring should be or how to check that out??
https://my350z.com/forum/exterior-an...l#post10994098
As far as the wiring on the spec D lights, you may need to modify it accordingly.
#3
New Member
You'll need a wiring diagram to sort this out, and a DVM (volt/ohm meter).
The Factory Service Manual is available for download (the link was recently, kindly, shared again in this post: https://my350z.com/forum/2003-2009-n...l#post11096112 ).
Good luck!
The Factory Service Manual is available for download (the link was recently, kindly, shared again in this post: https://my350z.com/forum/2003-2009-n...l#post11096112 ).
Good luck!
Thread
Thread Starter
Forum
Replies
Last Post