christoc

iTrader: (2)

Oh boy this should be good

sig11

iTrader: (3)

So the fella behind you doesn't plow into you?

edit: OOh. Beaten. :P

mhoward1

Not to mention almost all track safety inspections require the lights to be working. I know we will pull you from the track if your brake lights are not working.

KingBaby

iTrader: (3)

you can kill the control box

str8dum1

iTrader: (11)

No, you just unplug the abs motor under the hood next to the brake booster. Its the top grey connector.

tougeracing

The one from behind the steering column? or the g/yaw sensor box behind the ash tray? I might just go with the unplug at the engine bay. Before I had the Z I had a 240sx without a speedo, so I think I can get use to that.

I have a 04' Perfmance trim Z; I'm not sure if the plug is anywhere different than the other trim models. I should probably take a picture so you guys can see and for future reference for others.

str8dum1

iTrader: (11)

yaw sensor has nothing to do with ABS.

he means the ABS controller behind the steering wheel. Much easier to just unplug the ABS motor under the hood.

tougeracing

I attached a photo. Is this the grey plug I disconnect under the hood? Any special instructions like make sure the car is off first before I unplug?

Thanks for the helps everybody

dnguyent

iTrader: (5)

That's not the one I unplug. The one that I unplug has a locking lever on it, and to see it, you need to take off the plastic shroud. Just remove a few more of those tabs, and lift up the shroud. You should see another plug that is elongated...it's located near the side wall. I've put a box in the area where you can find the plug. One caveat to my comments...your ABS unit looks different than mine. I have an '04 Enthusiast.

If you still have a hard time finding it, PM me your cell phone number, and I'll try sending you a photo of it via text messaging.

-Don

tougeracing

Yeah I have 04' Performance trim. I'll take a look at it later and see if I can find it. Thanks for the help.