Lowering Springs Picture Thread
#401
Thanks Trav,
Do you have any pics with either of those coils on a 40 profile tire? I am good with a 1-2 finger gap if that is the case. What did you end up switching out for? tanabe GF120s? those were my second choice but I saw some pictures and the front of the 40 profile tire seemed like it tucked just a hair under the front fender (which is too low for me).
Thanks!
T
Do you have any pics with either of those coils on a 40 profile tire? I am good with a 1-2 finger gap if that is the case. What did you end up switching out for? tanabe GF120s? those were my second choice but I saw some pictures and the front of the 40 profile tire seemed like it tucked just a hair under the front fender (which is too low for me).
Thanks!
T
#403
In this picture, do you recall the spring set-up? also are these the 40 series profile tires?
Also with this drop, I was planning to do upper control arms (Kinetix), however since its roughly 1 inch drop I was also thinking just ugprade the OEM upper control arm bushings to whiteline perhaps (instead of buying whole new Kinetix UCA). What is your input between the 2 at this height (ideal height is the picture below).
thanks!
Last edited by Bak3rme; 07-22-2018 at 07:50 AM.
#405
Btw.... most alignment places wont touch the fronts since they are not adjustable from the factory. I had my spc's essentially zeroed out in front since i didnt autocross or race
some tuner shops may mess with them, the kinetix are more easily adjustable than the spcs
some tuner shops may mess with them, the kinetix are more easily adjustable than the spcs
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM