When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
If you are im having the S7 cams put in my revup engine(.450" lift). What power gains have you seen from these cams, crank and wheel hp? input would be great. I will dyno with them when the engine is broke in.
you are doing pretty much the same thing i am doing. I am installing nismo r-tune cams(intake only) in my rev-up. I don't think anyone has attempted this yet except for one guy on here, but i do not know what his results where. The nismo race team was said to have done this and claimed decent results (again don't have any actual #'s). I already have the cams so mine will be going in during christmas break since i am busy with school right now
you are doing pretty much the same thing i am doing. I am installing nismo r-tune cams(intake only) in my rev-up. I don't think anyone has attempted this yet except for one guy on here, but i do not know what his results where. The nismo race team was said to have done this and claimed decent results (again don't have any actual #'s). I already have the cams so mine will be going in during christmas break since i am busy with school right now
Not quite. He's installing cams that were designed with the Rev-up motor in mind so he'll be using both intake and exhaust cams.
Yea its both intake and exhaust cams. Should be some decent gains i hope. Since im dropping compression a little, i plan to run more timing to get some power back hopefully i can get about 10 degrees more of advance in with the lower compression.
I've had it in my longblock for 2 months now...but have yet to start her up. But results will be skewed...since my TT kit is being put on at the same time, and my heads have been reworked.
Even if they are for TT setups they still have more lift and duration, and anyway less overlap is always good. The lopey idle you hear from muscle cars is due to lots of overlap. I dont think the C8 cams are in production yet.