Hello all ,

Here is 2 of my dyno runs on a Mustang Dynometer same dyno same day , similar conditions ( with in 10-15 degrees of eachother )

My Z is an 06 with about 9800 miles as of these runs .

My mods were at the time of dynoing :

Kinetix Resonated Test pipes , Alphawerks stainless headers , Motordyne 5/16 iso spacer , Motordyne MREV2 , JWT pop charger , Greddy Muffler .

1st run is without the TP's , Spacer and MREV2 . ( NOTE: uncorrected was 258whp , but it was about 55 degrees )

2nd run is with the above's missing parts . ( NOTE : was about 62-67 degrees )

My base run was 245 WHP and 221 TQ .

All dyno runs are on the same Mustang Dyno .

I just got the X02 exhaust ( HKS replica ) put on and i hope to dyno it with in a few weeks .

Hopefully With the exhaust I will be around 260 +whp and 250+ TQ .

 

No bad at all, this is how I dynoed on Sharif's dyno.

https://my350z.com/forum/showthread....ht=06+dyno+run

and here are my mods:

https://my350z.com/forum/intake-exhaust/227354-my-new-mods-installed-by-forged.html

Matt