Help w/ Nardi/Personal with Works Bell QR
#82
so to confirm- your check engine light came on the same time as your airbag light?
hm. shouldnt have. they're totally unrelated. if ur SLIP light comes on, thats cuz you installed your hub too far over to one side or another.
check engine light removal is either with ECU reset procedures or obd2 port clear.
maybe its something else u did...
hm. shouldnt have. they're totally unrelated. if ur SLIP light comes on, thats cuz you installed your hub too far over to one side or another.
check engine light removal is either with ECU reset procedures or obd2 port clear.
maybe its something else u did...
#86
Registered User
iTrader: (1)
Join Date: Jun 2007
Location: globetrotter
Posts: 1,770
Likes: 0
Received 0 Likes
on
0 Posts
Also, check to see if you have everything grounded properly. Most hub kits come with separate spacer type peices that act as grounds. They go before and aft of the adapter.
#87
Registered User
iTrader: (10)
Join Date: Jun 2003
Location: So CA
Posts: 201
Likes: 0
Received 0 Likes
on
0 Posts
you need resistors for the air bag sensors. (sorry, i didn't take the time to read to see if you installed these)
Also, check to see if you have everything grounded properly. Most hub kits come with separate spacer type peices that act as grounds. They go before and aft of the adapter.
Also, check to see if you have everything grounded properly. Most hub kits come with separate spacer type peices that act as grounds. They go before and aft of the adapter.
yeah i installed both resistors for the air bag sensors. everything was grounded properly.. i think.. i need to double check because i know i had one extra piece of metal looking spacer left over..
#88
Registered User
iTrader: (1)
Bewteen my Momo wheel, quick release and bells works hub, I ended up with an extra grounding ring as well. You only need one ring.
I used mine between the wheel and quick release, which is not a good enough ground. Someday when I get off my *** I will put it between the quick release and hub where it should be.
I used mine between the wheel and quick release, which is not a good enough ground. Someday when I get off my *** I will put it between the quick release and hub where it should be.
#89
Registered User
iTrader: (10)
Join Date: Jun 2003
Location: So CA
Posts: 201
Likes: 0
Received 0 Likes
on
0 Posts
hi everyone.. im removing the personal wheel and hub now. i realized when i removed the wheel i got a SLIP light as well as my TCS light. anyone know how to remove this light? thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
ars88
Zs & Gs For Sale
18
04-04-2016 07:52 AM