Should I Or Shouldn't I ? ...
#6
Registered User
Thread Starter
iTrader: (2)
Join Date: Mar 2005
Location: Chatsworth,CA//Augsburg,GER
Posts: 1,536
Likes: 0
Received 0 Likes
on
0 Posts
okay thanks, thats what I thought you guys would say....anywho how am I gonna get these headlights, I know there is DIY but I'm just to scared to fck up my headlights.. + I wanted to get the 06+ headlights ....
Trending Topics
#18
350Z-holic
iTrader: (60)
Join Date: Jan 2006
Location: San Antonio/I miss DFW, TX
Posts: 11,204
Likes: 0
Received 28 Likes
on
19 Posts
Don't be scared......follow the DIY "how to" we have in the DIY forum and if anything leave it in a bit longer versus taking it out and trying to pull apart then putting it back in............i believe the DIY states 7 or 8 minutes and if not put it back in for another 7 or 8 minutes........
I went straight for 15-18 minutes each side and the housing pulled apart first try and the plastic was warm/but no where near "damaging" like you guys are fearing..
if not, find someone in your local area on the forum thats done it before and have a DIY headlight mod day...
give it a shot..
-J
Last edited by JasonZ-YA; 12-09-2009 at 10:04 AM.
#19
Registered User
iTrader: (12)
Join Date: Jul 2006
Location: Plano, TX
Posts: 740
Likes: 0
Received 0 Likes
on
0 Posts
dude guys seriously its not hard............I completely understand your thoughts on this, but its not like your putting a cake in the oven.....it takes more than 250 degrees and 15minutes x a few tries to melt plastic.......
Don't be scared......follow the DIY "how to" we have in the DIY forum and if anything leave it in a bit longer versus taking it out and trying to pull apart then putting it back in............i believe the DIY states 7 or 8 minutes and if not put it back in for another 7 or 8 minutes........
I went straight for 15-18 minutes each side and the housing pulled apart first try and the plastic was warm/but no where near "damaging" like you guys are fearing..
if not, find someone in your local area on the forum thats done it before and have a DIY headlight mod day...
give it a shot..
-J
Don't be scared......follow the DIY "how to" we have in the DIY forum and if anything leave it in a bit longer versus taking it out and trying to pull apart then putting it back in............i believe the DIY states 7 or 8 minutes and if not put it back in for another 7 or 8 minutes........
I went straight for 15-18 minutes each side and the housing pulled apart first try and the plastic was warm/but no where near "damaging" like you guys are fearing..
if not, find someone in your local area on the forum thats done it before and have a DIY headlight mod day...
give it a shot..
-J