Motor Stumble "loop"
#21
New Member
iTrader: (8)
Join Date: Jan 2007
Location: terre haute, IN; STL, MO
Posts: 6,457
Likes: 0
Received 7 Likes
on
6 Posts
sickness! i'm going to get a used ecu and see if that doesn't solve some of my other issues i've had with timing not holding and the variance from left and right banks that hal couldn't get fixed.
#22
Registered User
Thread Starter
Ordered (and paid for) a new ECU. Should arrive in a couple days. That means I'll have a toasted ECU available for testing if anybody wants it. At the very least it could help narrow down the cause of a particular error.
#23
Registered User
Thread Starter
The new ECU solved my problem! The electronic gremlin is gone and I have smooth response without any noticeable glitches. It's great to drive but I have not done anything beyond the base tuning that comes on the OEM ECU.
After driving it for about two weeks, yesterday it refused to start on me. After a couple of hours I tried again and it worked. Drove to work, lunch and back to the office this morning and when I tried to leave for the day - no start. The starter turns over easily, but just keeps cranking. Both times the car was warm, but not hot.
Got fuel pressure, not sure about spark. Hard to check in a parking garage. Guess it's a tow truck back to my tuner for hot/cold start tweaks.
After driving it for about two weeks, yesterday it refused to start on me. After a couple of hours I tried again and it worked. Drove to work, lunch and back to the office this morning and when I tried to leave for the day - no start. The starter turns over easily, but just keeps cranking. Both times the car was warm, but not hot.
Got fuel pressure, not sure about spark. Hard to check in a parking garage. Guess it's a tow truck back to my tuner for hot/cold start tweaks.
#24
Registered User
Thread Starter
The non-start issue was a wet wire harness. Got everything dried out, then re-sealed the firewall wire harness boot. No problems since then.
New ECU is all good - build is running like butta.
New ECU is all good - build is running like butta.
#26
Registered User
Thread Starter
I gotta agree with you.
Now that I have all the PLX modules and the Haltech as well, things have been moved around with a possible future leak in mind. It's all sealed up but I tried to give the electronics a better chance at surviving a failed boot.
Now that I have all the PLX modules and the Haltech as well, things have been moved around with a possible future leak in mind. It's all sealed up but I tried to give the electronics a better chance at surviving a failed boot.
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM
ars88
Zs & Gs For Sale
18
04-04-2016 07:52 AM