terrasmak

iTrader: (8)

Get it aligned, measure, then add spacers.

kakirk30

Ok wondering if this will fit. I am ordering wheels this week. I do not want to roll my fenders and I will be lowering on Tein S Tech which is about a .6 inch drop.
Wheels
Front-
GramLights 57GETTER in 18x9.5 +22
Rear-
GramLights 57GETTER in 18x9.5 +12
Tires
Front- 245/40/18 Dunlop Direzza DZ101
Rear- 245/40/18 Dunlop Direzza DZ101

Thanks, Kaleb

tbruner

iTrader: (5)

18x9.5 +10 Front
18x10.5 +12 Back

Front- 255/40/18
Back- 275/40/18

Lowered on GF210's 1.2" drop

SerG35ei

tbruner, post the picture(s) from the back, please.

tbruner

iTrader: (5)

NoQuestionZ

iTrader: (93)

^^ front looks spot on to me..... I have GF210s too and the rear just aint low enough! I did the spring mount mod Monday, but haven't taken it out of the garage to see if it did anything (kinda hard not to, but ya know).

I think all your car needs is 06+ tails.... I miss the stock lines from time to time....

I hope I can get it out after work today to run some errands and maybe even wash her. I'll post pictures if I can.

tbruner

iTrader: (5)

I agree the rear is a little off and needs a spring mount mod. As for 06+ tails and anything else, I'm looking into moving on to a newer z.

ksuberk54

iTrader: (2)

In for new pics

john blutarski

I'm considering a set of Enkei TSP6 wheels with the following specs-

Front - 18x8.5 +25mm offset
Rear - 18x9.5 +15mm offset

The car is an 08 and currently is at stock ride height with stock spec alignment. I may do a mild drop at some point 1" or less.

What size tires would you recommend that won't rub or require rolling?

Thanks

turboed350z

245 up front. 275 in the back will probably work.

travlee

iTrader: (8)

search is your friend... this has been answered many of times

but i run 275/40 and 255/40

john blutarski

^^ sorry, I have been searching but I wasn't sure on this exact wheel size, offset and suspension combo

john blutarski

What wheel size and offset are you running with these tire sizes?

travlee

iTrader: (8)

18x9.5 +23 front
18x9.5 +15 rear

5mm spacers front and rear... need to take them off the front, i rub on something when i hit a good bump

travlee

iTrader: (8)

i am lowered one inch on eibach pro kits, with tokico d-spec shocks... rear fenders rolled

john blutarski

^thanks

RedScytheZ

iTrader: (4)

Travlee: I am about to order springs and rear tires to finish my setup already. Would a 1.25" drop be too much here? Could I use 265/40/18 in the rear instead? I have 18 x 9.5 + 26 square, will roll rear fenders, and have a pair of 255/40/18.

Spike100

Go with 245/40-18" Front and 275/40-18" Rear.

travlee

iTrader: (8)

you should be good, and with that setup you shouldn't need to roll the fenders. when i was 9.5 +23 in rear i didn't rub with a 275/40, only when i went to a +15 did i rub

RedScytheZ

iTrader: (4)

Thanks spike and travlee.
275 40s for the rear it is.
I know someone that can install the springs and do the fenders for a reasonable deal. I'll roll them anyway just in case I want to play with spacers.