Aggressive Wheels and Stretched Tires....Welcome
In for more pics of your car!
hey guys, i felt in love with work vs-fx... however work doesn't offer super low offsets.
So I'd go with the following sizes:
F: 19x10 et 0 a-disk
R: 19x11 et +11 o-disk (will i need a spacer ? if so, should I go with a-disk et 0 instead ?)
I love flushness but i don't wanna end up with a **** load of poke like some of the setups on here... props to you guys tho! I've been reading the thread a lot and i think I'm going the good way for what I want, i'd just like to have a confirmation please before spending a couple of g's on a set of wheels. I'd also like some tire suggestions please!
thanks guys
So I'd go with the following sizes:
F: 19x10 et 0 a-disk
R: 19x11 et +11 o-disk (will i need a spacer ? if so, should I go with a-disk et 0 instead ?)
I love flushness but i don't wanna end up with a **** load of poke like some of the setups on here... props to you guys tho! I've been reading the thread a lot and i think I'm going the good way for what I want, i'd just like to have a confirmation please before spending a couple of g's on a set of wheels. I'd also like some tire suggestions please!
thanks guys
Fellow tuners,
I figured this would be the obviously place to get some pointers. I trying to run a 25mm spacer front and back. Would this be too much? Would I have to stretch my setup for this to work? If I went below a 25mm spacer, I would have to replace the wheel studs with shorter ones and a spacer. Due to the fact my wheels don't have "gaps/cavities."
Current
19.0 x 9.5 +28 - (+3)
19.0 x 10.0 +18 - (-7)
I will change these sizes when it's time for new rubber.
245/35/19
275/30/19
This is how it sits at the moment. I haven't installed my camber kit and toe kit just yet. I'm not lowered all the way either. Opinions?

-JP
I figured this would be the obviously place to get some pointers. I trying to run a 25mm spacer front and back. Would this be too much? Would I have to stretch my setup for this to work? If I went below a 25mm spacer, I would have to replace the wheel studs with shorter ones and a spacer. Due to the fact my wheels don't have "gaps/cavities."
Current
19.0 x 9.5 +28 - (+3)
19.0 x 10.0 +18 - (-7)
I will change these sizes when it's time for new rubber.
245/35/19
275/30/19
This is how it sits at the moment. I haven't installed my camber kit and toe kit just yet. I'm not lowered all the way either. Opinions?


-JP
<a href="http://www.flickr.com/photos/35049390@N05/4868481715/" title="IMAG0017 by sloopez53, on Flickr"><img src="http://farm5.static.flickr.com/4139/4868481715_c8998b4f9e_b.jpg" width="1024" height="612" alt="IMAG0017" /></a>
Driving down to FL, I passed by a minivan and in the passenger seats they were playing a **** movie. it was 2 am in the morning... sh*t so VIP!!!!!





