im looking at getting the the Enkei NT03+M wheels.

Front:18X10.5 +30 offset
Rear:18x10.5 +30 offset

Is there any problem running 10.5 all the way around. Is there a diffence with using a staggered look.

What size tires should i be looking at.

 

that offset might be pushin it in the front, might have to roll the fender ...but the rear is good, thats what i have and no roll was needed even when i lowered mine. i would go staggered only cause unless u r tracking the car and want a square setup its pointless imo. i have 305's on my 10.5 rears....they can handle up to 335's but thats a ton of tire and $$$$...for the front stretch a 275 im thinkin....

 

I have the staggered set of those. Possibilities are endless, 275/35 front and 295/35 rear , 245/40 or 255/40 front and 275/35 rear. None of those will rub, you can see pics of my car under my profile, but i run a 20mm rear spacer and 10mm front spacer.

10.5 in the front, don't know. Never tried to fit them, don't know if they will fit or not. May need a 5mm spacer to keep them from rubbing the inside.

 

Yea you might need a spacer in the front.

 

so 275/35-front and 295/35-rear will look the best for those set of rims.

 

it will need a spacer up front and it doesn't clear a big brake kit up front (not by a long shot)

 

9.5 front clear BBK's no problem. I have heard that 13 inch kits may require a 5mm spacer, and i know 14inch kits clear without.

 

but 10.5 +30 doesn't

not all 9.5 clears either...it depends on the offset. There are no absolutes with 13 inch kits fitting/not fitting or 14 inch kits fitting or not fitting. It all depends on the specific kit - they each have different clearance needs, sometimes by substantial amounts

 

i dont have a big brake kit, nor will i get one, maybe just aftermarket rotors and pads. I would like to have a neurtal stand with 10.5 all the way around. i dont mind getting wheel spacer, but wondering what size to get 15,20,25mm (Front/Rear)? and what size tire will look and fit the best?