no..... find better

 

 

No, it won't "mess anything up" other than the possibility of it looking a little off (but not anything terribly noticeable). Whether it's "worth it or not", no way to tell, don't know what kind of wheels you're talking about. It's not just about the size it's about the type of manufacture it is. If they are forged Volks or some MAT Enkeis then maybe. Cheap gravity cast, well, they're going to be junk regardless of size unless all they're for is street/commuter use.

 

1. they are Volk TE37. Bad thing is they are 5x120 lug so I’m Also stuck on if I should buy an adapter for it or keep looking. They’re selling fit 1800

 

Get the right lug pattern

 

Keep looking. Hmmmph, perish the thought of putting BMW wheels on a Z!!

 

someones exaggerating

 

Front 19x9 with tire size 245/35/19 offset 22. Rear 19x11 285/30/19 offset 23 volk TE37 with michelin sports tire with 65% tread left for $3500. is it worth it? and will the rims fit in my car with that tire size

 

Im planning on buying 18x10.5 ssr rims and I'm also planning on buying new toys tires but don't know which size to get without rubbing. I'm on stock height. And would these rims with tires rub?

 

Will fit, but TCS will not like it.

 

what about the SSR rims? any tire recommendations?

 

Getting 245/40/18 or 255/40/18 with 18" x 8 1/2" +20 offset and 275/40/18 with 18" x 9 1/2 " +20 offset. 2006 Nissan 350Z roadster. stock suspension. Any problems seen? Thank you

 

Nope. Works fine.

 

See these at an amazing deal gonna use this as my drag set since the set are forged and enEki figured they'd be good for a weight reduction and wider than stock for drag night.

 

Hella sunk in

 

Guess that's a no?

 

Was asking noob tire size and spacer questions but found everything here:
https://my350z.com/forum/wheels-and-...ml#post7149697

 

So i'm in the market for 350Z and would like to know in advance is my desired wheel/tire combination even close to fitting

265/30R19, 19x9.5 et12 or 22
295/30R19, 19x11 et22

I would like to keep the camber between -1 and -2. Car would be getting coilovers and lowered ~2-3cm (around 1"). Rolling and slightly pulling the fenders is fine.

 

I'm looking to put 50mm (2") spacers on all tires.

225/45/18 front and back
stock height and camber to my knowledge. 03 touring

 

So what’s your question?