Oil pressure sending unit issue
#1
Registered User
Thread Starter
iTrader: (6)
Join Date: May 2009
Location: Marysville, CA
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Oil pressure sending unit issue
Hey friends, doing an upper oil pan replacement on my z and ran into an unexpected issue while screwing in the oil pressure sensor. It will only screw in about halfway, all parts are OE Nissan also.
Here's a picture
Here's a picture
Last edited by zenki_z33; 06-28-2014 at 02:34 PM.
#2
General & Tech Moderator
MY350Z.COM
MY350Z.COM
Can't get the pic...
#5
Registered User
Join Date: Nov 2013
Location: Phoenix
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
I need to replace mine too as It recently went bad. I see some of the threads on her and people stating they stripped or broke the upper oil pan completely. Is that common or just from people over torquing?
#7
Registered User
Join Date: Nov 2013
Location: Phoenix
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
I usually and not afraid of doing some of my own stuff, but seeing how easily the parts were busting/cracking (when people claimed all they did was try to loosen the stock sensor) was a bit worrisome. It doesn't help that my torque wrench recently busted either and I need to get a new one that is capable of 10lbs.
I am debating just taking it to Nissan. That way if it busts while they are taking it out it would be on them. Still a bit unsure though.
Trending Topics
#8
350Z-holic
iTrader: (13)
a ring or two of teflon tape and 9 ft*lbs of torque. EM-26 in the factory service manual.
Thread
Thread Starter
Forum
Replies
Last Post