Bmurray350z

iTrader: (34)

Put it up in the air to replace the rear drivers side wheel bearing for the 3rd time in the past 2 months now... Lifetime warranty ftw. Also took my v2 kit to my buddy he's gonna change up the look for me.

Nismo350z#0310

iTrader: (1)

^ Dang man. Diagnosed what the deal is? Btw, I think I'm starting to experience vibrations/"rough" feedback at highway speeds. Maybe even a slight noise. You think it could be a wear bearing? Not sure what to make of it. I don't think its tires, they look perfect.

Nismo350z#0310

iTrader: (1)

+1 Steven!

Jbakes727

iTrader: (3)

Me and my buddy decided to clay bar and wax our Zs to get them ready for Simply Clean 5.

KingBaby

iTrader: (3)

continued to wire tuck the engine bay...

I'm a scaredy cat when it comes cutting wires so if I can cut metal feel better ? lmao




In the first pic the tip of the flat head points to a hollow point that exits out to picture two?

any inputs?

terrasmak

iTrader: (8)

Moved it out of the garage to work on the Jeep. Plates get turned in on it tomorrow.

meanz

iTrader: (23)

wet sanded my headlights with 3 and 4k sand paper, then used some meguiars plastix on them. Had some gunk on them that wouldn't wash off for anything.

ksuberk54

iTrader: (2)

Trying to decide if I want to get my car fully detailed or wait until the spring since we're going to be having snow and ice and I won't be able to drive my car very much. When I do though, I want it to look sick!

taywan

iTrader: (53)

You need a real 'taywan' buff on the lights. Make look brand new and its 1/2 price for ya.

meanz

iTrader: (23)

Hey man, takin real good care of your z and nsx... How's the trip?

tbruner

iTrader: (5)

Smog

terrasmak

iTrader: (8)

Moved it to the far corner in the garage where it will sit for the next 7 months.

Nismo350z#0310

iTrader: (1)

I get so jelly over this.

Zswagg

Did you use any type of compund after the wet sand? Or just the Meguiars Plastix?

meanz

iTrader: (23)

I only used the plastix, prolly should put somethin else on them, but for now they are nice and clear. Smooth as glass. Don't look to bad for 11 year old lights.

kaze06

If you want it to last you should probably apply a new UV coat.

Usually if you sand headlights down to clear them up, they come back fifty times worse in 6 months after sitting in the sunlight with no UV coating on them.

Zswagg

meanZ thanks man. l'll have to try it out because the previous owner tried to clean them up but did a horrible job on the lights huge swirl mark

Zswagg

Kaze06 where can I get the UV coating at, and what brand works best?

FamilyTradition

Cold but beautiful afternoon here. Took the Z out for a cruise on my favorite country road.

Then out of nowhere this cat comes flying out a ditch right at me. I blew it about 20 feet the opposite direction.
Car is ok, cat took off running.
It was a black cat too. Hope it didn't curse my car with bad luck.

Neeko94

iTrader: (2)

Obviously not going fast enough