What have you done for your Z today?
#9862
New Member
I have that same jack!
#9863
General & Tech Moderator
MY350Z.COM
MY350Z.COM
PP08. You're all right, man. Bleeding for your car. Enjoy!
The following users liked this post:
PP08HR (08-29-2015)
#9865
New Member
People seem to blow the white line bushings in a short time, wondering if I just get metal bushings
#9868
Registered User
Any horror stories from installing the whiteline bushings? I blew out my subframe bushing a few months ago and keep putting off throwing in my new whitelines. I'll definately follow Jason's write up in the tech section.
#9869
New Member
iTrader: (6)
Just the old bushing rear diff bushing removal was a pita to remove. I ended up cutting it out and using an air hammer and reciprocating saw. Putting in the bushings was easy. I froze the big one and it went in with a few taps.
Last edited by clubhopper; 08-29-2015 at 07:53 PM.
#9872
Registered User
Good to hear. I hope to get the new bushings in this month. Funny you should mention a good set of rubber. Just this morning I ordered the tires for my new wheels that have been sitting in my dining room since April.
#9875
Got my Kinetix adjustable upper arms from Z1 Motorsports in the mail and spent the afternoon installing them. Now I just have to take it to an alignment shop. Maybe I'll get more than 6 rack days out of the new RS-3s.
#9876
6 inch cawk is my fave!
iTrader: (3)
I put in my back window, going to go ahead and put that on the list of things never to do again. Deff not worth doing myself. Didn't come out bad but could be better, and lots of mess to clean up.
Hopefully it doesn't leak, or fly off. Seems stronger then the rest of the hatch so pretty sure it's notI going anywhere.
Ok an hour later I guess it wasnt that bad.. My dumb *** would probably do it again.
Last edited by dboyzalter; 09-02-2015 at 10:14 AM. Reason: feeling better
The following users liked this post:
jg021v (09-03-2015)
#9879
Registered User
Did a test drive with the dealer tech to verify that it needs a rear wheel bearing, and booked it in for Wednesday to get it replaced and for a CEL and airbag light diagnostic.