Just for fun, seeing what y’all think. I have a 2006 350z DE non rev up. FBO e85, and jwt c8 272 cams, the motor is currently being built with a z1 stage 3 rebuild kit with high compression pistons 11.1
What do y’all think it’ll run in the 1/4 mile and any guesses on a reasonable whp?
also it’s a 5at with a transgo shift kit.
here’s my full mod list:

Built VQ35DE with 11.1 pistonsIntake:

AdminTuning 3.5” intake

Carbon Fiber Intake Duct

NWP 75mm Throttle Body

Kinetix V+ Intake Plenum

Ported & Polished Lower Plenum

Ported & Polished Intake Manifold



Cams:

JWT 272 C8 Camshafts

JWT Valve Springs & Shims

Rev-up Oil Pump Upgrade



Exhaust:

DC Sports Ceramic Headers

1320 Resonated Test Pipes

ISR Performance Y-Pipe

Invidia N1 Exhaust



Fuel System: (e85)

Walbro 255lph Fuel Pump

Bosch 630cc 60lb Injectors



Rear End:

370z Sport 3.69 VLSD Differential



Wheels & Tires

Rays 370z Sport Wheels 19”

Front tires -Goodyear Eagle F1 255/40/19

Rear tires - Goodyear Eagle F1 295/35/19

Estimated 1/4mile times/speed? Estimated whp?
Also, what do y’all run in the 1/4 mile?

 

A built with your setup with 11:1 is probably 280hp ... It's hard to say what it'll do in a 1/4 ...

 

low 14s. Maybe, assuming you dont have a proper suspension setup or diff bracing and, on street tires.
Building a DE for NA power is kind of meh when you start talking about 10-20k in and you didn't spend the 3-5k for an HR that can hit 330+ fairly easy with out touching internals.

 

I’ve already ran a 13.75 at 101mph with just intake, throttle body, test pipes, catback and tune.

 

Then you already have a good Idea what it will Run then!
You may pick up 2-3 mph
Not really sure about all the changes you made but Motor?

All my Info is in my Sign!

Good Luck

 

I'm going to say you will make ~280whp as well since you are going through and auto. If you was 6Mt you would be ~300whp. If you can 60' I think you'll crack off a 13.5 but that will all depend on air conditions.

 

My goal is to break 285whp and run under 13.5, if I can do that, I’ll be very happy. I’ll be sure to update in a few months when I dyno and run it!
I just bought a manual c6 Grandsport... hopefully the built 350z doesn’t get too boring 🥺

 

What are you tuning with and if you aren't shooting for 12's with all that work it almost seems not worth it to save half a second

 

Lol, what? How slow is your Z?

 

Uprev with Martin at RS Enthalpy.
and low 13s or high 12s is a definite goal! I just don’t really know what to except. Havnt talked to many guys with built cammed n/a de’s.

 

I think you can hit 12.9 *FINGERS CROSSED*