Homemade Splitter Design and Mounting
#121
I just noticed you did that too. I also made a shroud on the inside to act like poor mans ducting to force air only to the radiator and oil cooler. Will try and get pics. I am not sure what angle is on the APR but I think it's the same. Least aggressive angle so far.
#122
Made some adjustments! Front grip is now INSANE. Much better than before. I put it on with no other changes other than lowering it, and the car had massive oversteer. Like terrasmak I had to increase the rear wing angle to try and balance it out.
It's also built like a tank. Survived two offs, with only a broken/ lost bolt that holds the main support onto the splitter itself. This is under heavy braking.
It's also built like a tank. Survived two offs, with only a broken/ lost bolt that holds the main support onto the splitter itself. This is under heavy braking.
#123
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
I don't remember what coilover you have but, if you have an adjustable body, slightly extend it to reduce up travel. If you have non adjustable body like mine, install a thicker bump stop , I just put some in mine , they engage 3/4 inch before the car bottoms out , the add 100lb of spring rate when they engage. You may also benefit from stiffer springs too. I have yet to test, but I went from a 700lb to 736lb front spring.
#125
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Dam, you really need stiffer springs. I don't know if you can add a larger bump stop with those shocks, maybe TrueChoice Koni can help. Send them in, revalve and get springs. I would really say 11k or up to about 650lb front and rear , those shocks from what i understand cant handle much more spring (even with the revalve)
#126
Registered User
iTrader: (51)
Dam, you really need stiffer springs. I don't know if you can add a larger bump stop with those shocks, maybe TrueChoice Koni can help. Send them in, revalve and get springs. I would really say 11k or up to about 650lb front and rear , those shocks from what i understand cant handle much more spring (even with the revalve)
#127
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
690lb f/r for the t2 springs. You can try, cant think of the name on here, but they could never get them to not blow when valved properly for higher spring rates.
Thread
Thread Starter
Forum
Replies
Last Post