DE and HR mod ideas I think of, opinions welcome
#22
Registered User
Thread Starter
Stillen uses 2.75 at the tb but uses 2.5 for the rest, same size as the OEM maf. The other intake systems use the larger piping throughout but still neck down at the maf. I'm going to try this one out and see if there's anything to be made. I already have an extra set of hr OEM intakes anyway.
The motordyne intake manifold for the 370 is just a 350 manifold. It does give up a little top end for a ton of midrange. The 370 still uses an exhaust cam that's no more aggressive than ours so its still up for debate I would think once cams are upgraded.
n
The motordyne intake manifold for the 370 is just a 350 manifold. It does give up a little top end for a ton of midrange. The 370 still uses an exhaust cam that's no more aggressive than ours so its still up for debate I would think once cams are upgraded.
n
i knew it was something like that with the motordyne 370 manifold , too bad they have VVEL heads. one way i look at it is if nissan didn't give the GTR VVEL then its not needed lol
Thread
Thread Starter
Forum
Replies
Last Post
wanderingstuden
Maintenance & Repair
6
01-28-2016 07:03 PM
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM