So, I took off the stock fuel pump and try to install the walbro in the housing, but I can't put the clip on support bracket at the bottom to go in and lock. Can I just put a cable tie to hold it? Please help!!

 

only 19 posts ago...
HOW TO: Install a Walbro GSS342

 

But I can't open the link to view the instructions

 

Have you looked at the Turbonetics instructions yet? http://turboneticsownersclub.com/tur...icsinstman.pdf

 

If I am running stock fuel rail and 440 cc injectors with the vortech, do I need to drill holes or remove anything from the fuel pump assembly?

 

Follow Phunks directions to the T. It is not hard!!

 

No you don't have to do any of that. Phunks directions are perfectly fine I was just trying to help you out since you seemed to indicate you couldn't open the link to his instructions.

 

Basically just to install the pump?

Thanks for all the input guys!!!!

 

Yup..

 

u need to shave off the 2 circular black tabs

 

....

 

why cant you view the link i posted?

 

ouch... thats not a very good setup!

 

link removed.. you can delete my quote if you want

 

Alternatively, my wife and I posted our Walbro experience

https://my350z.com/forum/forced-induction/304690-revup-vortech-installation-joining-the-ranks-of-fi.html

I hope it helps. We didn't get any pictures before we buttoned it all up but the written description is very good.

 

well... its actually a good link... its just the way they plugged up where the regulator goes... why would anyone want to eliminate half the gas tank?! otherwise the pics are good and useful for someone just putting in a walbro

 

I finally view the link, and the step by step is awesome. Thanks phunk

 

let us know if you run into any issues

 

What size of drill bit should I use to drill the swirl jet? Should i use the same bit for the regulator oulet oriface modification?

Thanks