Could any one with the new V3 unit chime in if this blower still has the rattle problems from the V2 unit??

 

mine still rattes, but not as bad as my previous V2. when i get to the shop, i'm going to have my idle bumped.

 

All gear driven blowers will rattle at certain lower rpm's due to gear lash. Raise your idle or put a smaller pulley on and it should go away.

 

Ive not got the V£ yet guys im just asking if the rattle is reduced in the new unit. I dont mind bumping my idle to 1200 rpm if need be?

Thanks for any owners comments.

 

1200? no thats too high, 900 is good

 

I don't hear any rattle...my idle set at around 1000~1100 rpms.

I have a problem that my blower is so quite!! lol

 

Thats what i wanted to hear!

 

where do you guys get the idle bumped? is it a reflash? i wanna bump mine to 1000-1100.

chef- got the dyno numbers today!!! its sick! ill make a thread soon

 

Congrat!!

 

unless you have a 2004 or earlier you have to geta ECU reflash to bump the idle. otherwise a cipher can do it.

 

I can't say much about the V3, but i idle between 450 to 500 with the V2. With very little rattling noise when I replace my throttle body due to a TPC code my idle went up 900 to 1000. Because my idle was higher i was throwing a ISC systems code I think the code number is 507 don't quote me on it lol. I went to the dealership got a re-flash to relearn ETC now car is running great end of story. If you ask me retune the SS box maybe even replace it for a UTEC, but I could be wrong.

 

i have an 03. Doesn't nissan have the cable? Do you think they can bump it for me? Shouldn't take long

 

You're going FI mate?

 

Yeah mate I think so.... Woohoo! Ha. I'm still in love with the GTM TT but fitting it in my garage is a big task. The vortech is no problem. Still I've gotta be sure what I'm gonna do before I drop a load of cash on it.

 

You're lucky you have a garage... I gotta do it in my driveway!
It says 10 hours to fit the vortech... imagine how long it'd take us?! lol

 

ya dealer can do it. will cost between free and $100 usually. depends on your dealer.

 

Yeah the garage will help mate but it's a small job compaired to the gtm ty install that would take me a week!

The install is on the intake side only and should not be to hard. I'm sure we could throw one on at the chilli's mod day!

 

They'll bump it up but they might not go over 900/950 rpm...CTA..