Friend of mine sent me this looks interesting

 

Want it, need a new throttle body anyway

 

It'll be 365 bucks

 

if that is true , then its correctly priced since those maxima 09+ Throttle body sells for around 170$ on ebay.

 

$365 for a plug n play larger throttle body that doesn't require tuning...comes with 75mm TB, tapered mounting plate & wire harness

Not too bad for +15hp top end gains on Z/Gs... https://www.facebook.com/NWPEngineering
The dyno they used for the Maxima was on an auto that only had NWP phenolic spacers and NWP block off plate as the other mods...so I would assume the Z/G they tested the new TB kit on were similarily modded.

 

Interesting

 

I have seen that guy around the track. He has an impressive car.

 

user surratt is supplying the adapter harness. there was a thread about this months ago. guess finally someone wanted to start making a huge profit on a 5mm TB difference.

 

Looks impressive.

 

hmmm, no tuning and +15hp is nice but idk if its worth $350~ish Curious on FI applications..thanks for sharing.

 

if there really is a gain I hope they make one for the hr or would it be the same?...It should I guess probably just buy 2 lol

 

i don't like the price either...also wonder how they plan to support the headache everyone will run into with the idle air relearn procedure LOL

 

That's a good point. I 'think' on previous installation instructions they included the 'pedal dance' procedure to fix any idle issues. I have their BOP and Spacers already...but I'm already headed down a different route as far as TBs are concerned.

 

I find it funny that some peoples are saying that 15whp doesn't seem to be worth 365$ ...
you guys pay for an exhaust in the 1000$+ for the same gain.
even some gets HFC at 400+ for 10whp ...

the more you mod the Z the les gain there is, and that 365$ is cheap ! when overall in NA fully bolts on cost quite over 50$/WHP

 

10mm difference, and 10mm is a lot of difference in volume

 

I thought stock z was 70mm like the 02-08 Maxima?

 

70mm is oem 350z 03-06.

The setup that is gonna be sold is with the the Maxima 09+ TB which are 75mm and compatible.

so its 5mm of difference and way more flow than 70mm.
it should be an easy swap once the relearn procedure are done properly.

 

just measured, I stand corrected. The MAF sensor housing is still 65mm and the choke point

 

they said it might not match up perfectly to the Kinetix V+ plenum, some porting might be required... hmmm

 

Oh ok...I'm running a 4" intake/maf setup so my current choke point is the tb.