CEL TCS OFF and SLip light on!!!!!!!
#1
Registered User
Thread Starter
Join Date: Jul 2012
Location: lewisville
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
CEL TCS OFF and SLip light on!!!!!!!
So i replaced my clutch the other day, and when i finally got it all done, i went to start my car, and it just kept turning over. After about five times it finally came on. Now my CEL TCS off and SLIP lights are on. Also when i am driving, i can feel the engine sputtering a little bit. Did something go wrong with the clutch install, is it another sensor that may have gone out? PLEASE HELPP!!!!!!!
#2
Registered User
Did you remove and reinstall the crank position sensor when you removed and reinstalled the transmission? It's on the passenger side of the transmission housing, near the top, right over the flywheel. If you didn't remove it, you may have bashed it into the flywheel during your clutch install. Or perhaps you forgot to plug it back in?
If you search a bit, there are a few threads mentioning an incorrectly installed flywheel causing similar issues. Apparently some of them can go on two ways.
Codes would be helpful here as well.
If you search a bit, there are a few threads mentioning an incorrectly installed flywheel causing similar issues. Apparently some of them can go on two ways.
Codes would be helpful here as well.
Last edited by patrickoneal; 08-19-2012 at 09:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post