post 1000!


so who's got it?? I/O box
http://cgi.ebay.com/ebaymotors/120749104608

digital inputs mean you can run a ETOH sensor without the Zeitronix box. Could also run a methanol flow sensor for real 3D meth injection . Just need the firmware to utilize those.

 

Any chance of getting the haltech software running on an android tablet? I mean, the tuning software, obviously, not the ecu itself.

 

New version of ECU Manager out, with CAN Input/Output box support!
https://my350z.com/forum/forced-indu...nsion-box.html

 

Can someone use the 350z unit to tune the 370z? Already have the HR harness.

 

Did the onboard logging go in the later ecu software? Can't find it in the 1.09 version of the software. Have searched high and low on here and internet to see where it went to and if it's taken off or just hidden somewhere else. I'm talking about the ecu onboard logging (That used to fill up after a short time) Just wanted to see what my water temps where like under some WOTs'. Not having my mini pc hooked up or external gauges to monitor it at the moment.

 

No, a 370Z harness is required. Contact us at Dynosty for 350Z HR and 370Z harness needs.

 

It has been there all along, and is found under the Datalogging tab under Main Setup. Also, you can access it at the bottom of ECU manager under the 'Data Manager' tab (both PC log and Onboard logging is available there)

 

Cheers the little tab down at the bottom had dissapeared somehow on my little eee pc In the older ones it was accessed through the menu if I'm not miss-remembering? Thanks Hal

 

There is a little message at the bottom of the ECU manager that indicates DTCs - can the new firmware trap DTC generated by the stock ECM?

 

No, that is for Pro Plug-In units (where the stock computer is replaced, such as S2000, RSX, etc)

 

Hal, any chance we'll see an E85 profiling feature on the Sport2000 boxes?

I'd have no issues adding a flex fuel sensor should the software become available to support the ECU switching automatically as it sees input from the flex sensor. I'd love to be able to mix pump and E85 without any concerns, as E85 is not readily available everywhere here in CA. It seems we really need a 3D map like Haltech has employed with the Pro ECUs.

 

Does the pro version support flex fuel sensors?

 

none of them do

 

I can see the flex sensor being used to adjust fuel, timing, and boost trims automatically via I/O lines. Not the same as interpolating between 2 maps but I think it could work.

 

I've been reading on the haltech forums people are getting it to work somewhat with other versions of the haltech and I saw a post mentioning about it being supported only on the platinum pro series units.

 

http://forums.haltech.com/viewtopic....&t=7247#p25217

 

The 350Z uses the Pro Harness series, so maybe that will get the update?

 

I emailed Scott @ Haltech (lead tech) and i got this reply:

"Currently there is no due date to support the GM Flex sensor on the Pro Harness ECU systems."

:-(