bluetooth mic placement
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: South OC, CA
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
bluetooth mic placement
Getting a DDX812 installed on the 21st and was wondering where you guys have the mic for the bluetooth module. Pictures would be great if you guys have them to.
#7
Do WHAAAAT!?
iTrader: (19)
Not really too tough. The A-pillar just pops off and I ran the wire behind/underneath the dash and back in behind the console. I think I used a couple of wire ties to hold the wire behind the dash. I also bent the bracket on the mic itself so it could slide down behind the A-pillar. When I got it, it was basically a clip and I straightened it out.
Trending Topics
#8
350Z-holic
iTrader: (60)
Join Date: Jan 2006
Location: San Antonio/I miss DFW, TX
Posts: 11,204
Likes: 0
Received 29 Likes
on
20 Posts
any other style of mics found and used by anyone........the cylindrical tube style like that one is not for me........wondering if anyone found one that mounts flag on surface? etc..
or maybe different mounts for them? etc?
-j
or maybe different mounts for them? etc?
-j
#12
New Member
iTrader: (1)
Hey guys sorry to be bringing up an old issue but I'm really torn on where to place my BT mic. I'm basically thinking of doing a variation of what TreeFiddyZee (and probably what many of you have done) did or try to drill a hole in the A-pillar and make it more flush/descrete. Anybody out there try the drilling method? If not, do you got any ideas on how I would keep the mic in place besides apoxy or tape? I basically want just the face of the mic showing through the hole. Open to ideas, was actually thinking of using a small peice of styrafoam.
Thread
Thread Starter
Forum
Replies
Last Post