i installed my zeitronix but the rpms must not be hooked up right, its not a big deal, just cool to have it on the data logger. i tied into the ECU harness at what i thought was the right wire, but there were 2 wires described in another post, does anybody know exactly which wire it is. right not the rpms dont get over 1k even when i punch it.

 

Wish I was at home and could give you the pin and wire color. However, do a search using: SungNamZ Then look for threads: Zeitronix

 

What do they recommend tapping? One of the ignition wires, or the crank angle wire?

 

They recommend tapping into #1 coil of ECU harness. I am sure Sharif can give you the pin and wire color.

 

You probably have it on the crank wire now , reading all 6 cyl. thats why it doesnt go over 1K rpm . Got to tap one cyl. You Might want to check your settings first . Select [ 1 ] cyl. instead of 6

 

thats possible boog, the settings on the software was set to 4, i changed it to 1, im gonna search for sungnamz post and see if ive used the same wire.

after looking at that info sungnamz, i read tha before installing mine, i hooked to the yellow/red wire right next to the one i used for the tps.

 

Terminal #62: RPM Signal Yellow/Red
Terminal #50: Throttle position sensor Green

 

Looks like it may have been just your settings then

 

yellow/red pin#62....


Wait...I guess I am too late.

 

I used #62. After adjusting the software setting, it seems to work just fine.

 

actually my #50 was white with a green stripe. anybody elses like that?

 

Tig,

I understand the Z-Tronic will also display fuel pressure. Is this true?

 

no, it doesnt display fuel pressure. it displays lambda, afr, boost, TPS, RPM, EGT, i believe thats all.

 

Dont remember , but some one was trying to hook it up to read fuel preasure . Think he was going to do it to read volts and see if they could convert it or some thing