VQ37VHR kinetix manifold.
06-13-2010, 12:27 AM
#41
Registered User
Join Date: May 2009
Location: Phoenix, AZ
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
06-15-2010, 08:00 AM
#44
Registered User
iTrader: (18)
Join Date: Sep 2008
Location: In your internets.
Posts: 1,335
Likes: 0
Received 0 Likes
on
0 Posts
Here's the thing... If this is the case, I'm jealous... Thus the reason I'm flaming you. Second, I don't believe you till I see pics.
06-15-2010, 03:01 PM
#45
New Member
iTrader: (5)
Join Date: Mar 2008
Location: Bx 2 Georgia
Posts: 493
Likes: 0
Received 0 Likes
on
0 Posts
on the bright side, John will be contacting Kinitex to get the ball rolling on a 350zhr specific version....so there is hope still.
06-15-2010, 05:21 PM
#46
Vendor - Former Vendor
iTrader: (4)
Join Date: Aug 2009
Location: Tulsa
Posts: 1,601
Likes: 0
Received 0 Likes
on
0 Posts
you will have to ask john if he took some pics. anyway, jus got back from Z1, the plenum does not fit, off by an inch or so clearance wise..
on the bright side, John will be contacting Kinitex to get the ball rolling on a 350zhr specific version....so there is hope still.
on the bright side, John will be contacting Kinitex to get the ball rolling on a 350zhr specific version....so there is hope still.
06-17-2010, 12:44 PM
#47
New Member
iTrader: (5)
Join Date: Mar 2008
Location: Bx 2 Georgia
Posts: 493
Likes: 0
Received 0 Likes
on
0 Posts
the prblem was on the underside from what i understand, didnt get much details. But i spoke to john yesterday and he said kinetix is addressing the issue. we will have one soon.
08-15-2011, 08:31 PM
#51
you will have to ask john if he took some pics. anyway, jus got back from Z1, the plenum does not fit, off by an inch or so clearance wise..
on the bright side, John will be contacting Kinitex to get the ball rolling on a 350zhr specific version....so there is hope still.
on the bright side, John will be contacting Kinitex to get the ball rolling on a 350zhr specific version....so there is hope still.
08-25-2011, 08:37 AM
#56
I read through the whole thread about that VHR manifold and being also tested on a HR engine ..
well good luck with that , the bolt pattern arent the same...
my current Intake manifold come from the HR and the 4 center bolt hole had to be modified. since Nissan didnt want us doing the swap from HR to VHR ...
you can also look at the Motordyne M370 which is the modified 350z HR intake manifold.
well good luck with that , the bolt pattern arent the same...
my current Intake manifold come from the HR and the 4 center bolt hole had to be modified. since Nissan didnt want us doing the swap from HR to VHR ...
you can also look at the Motordyne M370 which is the modified 350z HR intake manifold.
Thread
Thread Starter
Forum
Replies
Last Post
wren57
Intake Exhaust
11
03-25-2004 08:06 AM
